Free shipping on orders $149 $99 & up. exclusions apply

3/4" Male Pipe Thread x 1/2" Power-Loc Connector


3/4 in.  Male Pipe Thread x 1/2 in.  Power-Loc Connector
In Stock

The commercial grade 1/2" male adapter x 1/2" Spin-Loc connector is used to connect a 1/2" drip tubing or drip line to a main lateral with a 1/2" female pipe thread. To use this Spin-Loc fitting, push the drip tubing over the barb with the "O" ring and thread the sleeve over the drip tubing to secure. The tight seal for the Spin-Loc fittings is ensured by the rubber "O" ring on the barb, which provides a quality water-tight connection.

Part #: LF053R
$0.95 ea.

The Drip Store’s commercial grade Spin-Loc fittings are available in many configurations to meet the demands of all types off drip irrigation applications. Use the 1/2" Spin-Loc fittings in the layout and installation of 1/2" .700 OD polytubing.

The Spin-Loc fittings use a sleeve assembly over a body with a barb insert, allowing the user to easily install the many fittings that might be needed throughout the installation of the drip tubing. The sleeve makes the Spin-Loc fittings easier to install and tighten. An advanced sealing interface with a long barb provides guides for the Spin-Loc to slide over the barb for a secure seal. Our Spin-Loc fittings are made of high impact UV resistant plastic and can last for many years.

  • Maximum pressure: 60 PSI
  • Recommended pressure: Up to 30 PSI
  • Use with: .700" compression, nut lock and spin lock fittings
  • Available to fit 1/2", 3/4" and 1” drip tubing or drip line
  • Available with hose or pipe thread connection
  • Made with high impact UV resistant plastic
  • No glue or tools are required
  • Secure and easy installation without glues or clamps

Installation for Spin-Loc Fittings

The ½”, ¾” and1” Spin-Loc fittings uses a sleeve assembly over a body with a barb insert, allowing the user to easily install the many fittings configurations that night be needed throughout the installation of the drip tubing. The sleeve makes the Spin-Loc fittings easier to install and tighten. An advanced sealing interface with a long barb provides guides for the Spin-Loc to slide over the barb for a secure seal. Our Spin-Loc fittings are made of high impact UV resistant plastic and can last for many years.
 
To connect the spin-lock fitting to the drip tubing or drip line we provides a number of steps
Step 1: First, turn the sleeve of the fitting counter-clockwise
Step 2: Push the drip tubing or drip line over the barb all the way in or as much as you can
Step 3: Threaded the sleeve over the drip tubing or drip line to secure.
 
Using the Spin-Loc fittings, drip tubing can be installed easily either above or below the ground. Use the Spin-Loc fittings to connect the drip tubing with other sections of drip tubing or PVC pipe.