1/2" Spin-Loc Line End with Flush Valve
In Stock
The commercial grade Spin-Loc with flush valve is used for automatic flushing of the 1/2" drip tubing or drip line at the beginning and the end of the irrigation cycle. At the start up of the system, when pressure reaches 5-7 PSI, the flush valve closes, and when pressure drops below 5-7 PSI the valve opens. To use this Spin-Loc fitting, push the drip tubing over the barb with the "O" ring and thread the sleeve over the drip tubing to secure. The tight seal for the Spin-Loc fittings is ensured by the rubber "O" ring on the barb, which provides a quality water-tight connection.
(
1 rating/review )
The Drip Store’s commercial grade Spin-Loc fittings are available in many configurations to meet the demands of all types off drip irrigation applications. Use the 1/2" Spin-Loc fittings in the layout and installation of 1/2" drip tubing.
The Spin-Loc fittings use a sleeve assembly over a body with a barb insert, allowing the user to easily install the many fittings that might be needed throughout the installation of the drip tubing. The sleeve makes the Spin-Loc fittings easier to install and tighten. An advanced sealing interface with a long barb provides guides for the Spin-Loc to slide over the barb for a secure seal. Our Spin-Loc fittings are made of high impact UV resistant plastic and can last for many years..
By: jscruggszoo, 08/22/11
Another high-quality Spin Loc part you will want to have on hand. The flush valve helps you keep debris out of your lines.
- Flush Valve Closing Pressure:
7 PSI
- Flush Valve Opening Pressure:
7 PSI
- Maximum pressure:
60 PSI
- Recommended pressure:
Up to 30 PSI
- Available to fit 1/2", 3/4" and 1” drip tubing or drip line
- Made with high impact UV resistant plastic
- No glue or tools are required
- Secure and easy installation without glues or clamps
- Tight seal, ensured by the rubber "O" ring on the barb ( 3/4" & 1" do not use an "O" ring)
Installation for Spin-Loc Fittings
The ½”, ¾” and1” Spin-Loc fittings uses a sleeve assembly over a body with a barb insert, allowing the user to easily install the many fittings configurations that night be needed throughout the installation of the drip tubing. The sleeve makes the Spin-Loc fittings easier to install and tighten. An advanced sealing interface with a long barb provides guides for the Spin-Loc to slide over the barb for a secure seal. Our Spin-Loc fittings are made of high impact UV resistant plastic and can last for many years.
To connect the spin-lock fitting to the drip tubing or drip line we provides a number of steps
Step 1: First, turn the sleeve of the fitting counter-clockwise
Step 2: Push the drip tubing or drip line over the barb all the way in or as much as you can
Step 3: Threaded the sleeve over the drip tubing or drip line to secure.
Using the Spin-Loc fittings, drip tubing can be installed easily either above or below the ground. Use the Spin-Loc fittings to connect the drip tubing with other sections of drip tubing or PVC pipe.
Drip Fittings
