Free shipping on orders $149 $99 & up. exclusions apply

1/2" (16mm) .520 to .540 ID Starter barb connector with Rubber Grommet


1/2 in.  (16mm) .520 to .540 ID Starter barb connector with Rubber Grommet
In Stock

The 1/2" (16 mm) starter barb connector with rubber grommet is used for connecting a drip lateral with.520 ID to .540 ID (16 mm) into a main line PVC pipe. To connect the barb with the grommet into a PVC pipe, drill a hole using a 5/8” hall saw drill, insert the rubber grommet into the shorter barb side and push the assembly into the PVC pipe. Into the other side of the barb insert the drip tubing or drip line. By using the double barb the drip tubing is pushed over the barb for a very tight fit. Use this connector for a lateral layout of drip hose or drip line from a PVC main line.

Part #: LF314
$0.88 ea.

The Drip Stores’s black color 1/2"(16 mm) barbed drip fittings are available in a variety of configurations for 1/2" drip line or drip tubing with .520 to .540 (16mm) ID, providing a low cost and simple method for drip line and drip tubing installation.

  • Color: Black
  • Materials: Barb: Acetal
  • Operating pressure: up to 30 PSI
  • Use with: 1/2" drip tubing or drip line with .520 ID to .540 ID
  • Fits all brands of 1/2" (16 mm) polyethylene tubing or drip line with .520 ID to .540 ID
  • Made with high impact UV resistant plastic
  • Secure and easy installation without glues or clamps

1/2" Barb Fitting suggested installation steps

 

The 1/2" (16mm) barb fittings are used in the installation of any brand name drip line or drip tubing. To connect the 1/2” (16 mm) drip tubing or drip line, use a hand pruner to cut the drip tubing or drip line, being careful to keep dirt from entering the drip tubing. Insert the barb side of the fitting into the end of the 1/2” drip tubing or drip line by forcing the drip tubing over the barb side.