Free shipping on orders $149 & up. exclusions apply

1/2" (17 mm) .550 to .600 ID Barb Connector


1/2 in.   (17 mm)	 .550 to .600 ID Barb Connector
In Stock

The 1/2" (17 mm) barb connector is used to connect two ends of drip tubing or drip line with .550 ID to .600 ID (17 mm). By using a double barb, the tubing is pushed over the barb for a very tight fit. Use for continuing lengths of drip tubing or drip line and for drip tubing repair.

Part #: LF301
$0.29 ea.
  ( 2 ratings/reviews )

The Drip Store’s brown color 1/2" (17 mm) barbed drip fittings are available in a variety of configurations for 1/2" drip line or drip tubing with .550 to .600 ID (17 mm), providing a low cost and simple method for drip line and drip tubing installation.

By: Falcon Aloft, 11/13/12

A little hot water on the .620 tubing and these fit right in. Impressive apparent quality and design: heavy duty and easy to use. Requires strength in the hands to make the connection but yields a high strength bond that's virtually impossible to separate. Used in our nursery for a more precise and uniform installation where multiple tubes are present.

By: rharris1951, 06/16/11

  • Color: Brown
  • Materials: Barb: Acetal
  • Operating pressure: up to 30 PSI
  • Use with: 1/2" drip tubing or drip line with .550 ID to .600 ID
  • Fits all brands of 1/2" (17 mm) polyethylene tubing or drip line with .550 ID to .600 ID
  • Made with high impact UV resistant plastic
  • Secure and easy installation without glues or clamps

17 mm Barb Fittings

The 1/2" (17 mm) barb fittings are used in the installation of any brand name drip line or drip tubing. To connect the 1/2" (17 mm) drip tubing or drip line, use a hand pruner to cut the drip tubing or drip line, being careful to keep dirt from entering the drip tubing. Insert the barb side of the fitting into the end of the 1/2" drip tubing or drip line by forcing the drip tubing over the barb side.