Free shipping on orders $149 $99 & up. exclusions apply

1" Spin Loc x 5/8" Drip Tape Reducer Tee


1 in.  Spin Loc x 5/8 in.  Drip Tape Reducer Tee
In Stock

The commercial grade 1" Spin-Loc reducer tee is used to connect a supply line of 1” drip tubing (1.060 ID x 1.200 OD) to a 5/8" drip tape. To use this Spin-Loc fitting, push the drip tubing over the barb and thread the sleeve over the drip tubing to secure. Use this fitting if your rows of drip tape are longer than 50 ft.

Part #: LF125
$9.44 ea.

The Drip Store’s commercial grade Spin-Loc fittings are available in many configurations to meet the demands of all types off drip irrigation applications. Use the 1" Spin-Loc fittings in the layout and installation of 1” drip tubing.

The Spin-Loc fittings use a sleeve assembly over a body with a barb insert, allowing the user to easily install the many fittings that might be needed throughout the installation of the drip tubing. The sleeve makes the Spin-Loc fittings easier to install and tighten. An advanced sealing interface with a long barb provides guides for the Spin-Loc to slide over the barb for a secure seal. Our Spin-Loc fittings are made of high impact UV resistant plastic and can last for many years.

  • Flush Valve Closing Pressure: 7 PSI
  • Flush Valve Opening Pressure: 7 PSI
  • Maximum pressure: 60 PSI
  • Recommended pressure: Up to 30 PSI
  • Available to fit 1/2", 3/4" and 1” drip tubing or drip line
  • Made with high impact UV resistant plastic
  • No glue or tools are required
  • Secure and easy installation without glues or clamps
  • Tight seal, ensured by the rubber "O" ring on the barb ( 3/4" & 1" do not use an "O" ring)

Installation for Spin-Loc Fittings

The ½”, ¾” and1” Spin-Loc fittings uses a sleeve assembly over a body with a barb insert, allowing the user to easily install the many fittings configurations that night be needed throughout the installation of the drip tubing. The sleeve makes the Spin-Loc fittings easier to install and tighten. An advanced sealing interface with a long barb provides guides for the Spin-Loc to slide over the barb for a secure seal. Our Spin-Loc fittings are made of high impact UV resistant plastic and can last for many years.
 
To connect the spin-lock fitting to the drip tubing or drip line we provides a number of steps
Step 1: First, turn the sleeve of the fitting counter-clockwise
Step 2: Push the drip tubing or drip line over the barb all the way in or as much as you can
Step 3: Threaded the sleeve over the drip tubing or drip line to secure.
 
Using the Spin-Loc fittings, drip tubing can be installed easily either above or below the ground. Use the Spin-Loc fittings to connect the drip tubing with other sections of drip tubing or PVC pipe.