Free shipping on orders $149 & up. exclusions apply

1/2" (17mm) .550 to .600 ID Starter Barb Connector x Poly


1/2 in.   (17mm) .550 to .600 ID Starter Barb Connector x Poly
In Stock

Use this connector to start a drip lateral from a drip tubing. To insert it into a 1/2", 3/4" or 1" drip tubing, punch a hole into the drip tubing using the black punch with 8 mm pin and insert the small barb into the tubing. insert the other side side of the barb into a 1/2" or 17 mm drip tubing or drip line

Part #: LF318
$0.28 ea.

The Drip Store’s brown color 1/2" (17 mm) barbed drip fittings are available in a variety of configurations for 1/2" drip line or drip tubing with .550 to .600 ID (17 mm), providing a low cost and simple method for drip line and drip tubing installation.

  • Color: Brown
  • Materials: Barb: Acetal
  • Operating pressure: up to 30 PSI
  • Use with: 1/2" drip tubing or drip line with .550 ID to .600 ID
  • Fits all brands of 1/2" (17 mm) polyethylene tubing or drip line with .550 ID to .600 ID
  • Made with high impact UV resistant plastic
  • Secure and easy installation without glues or clamps

17 mm Barb Fittings

The 1/2" (17 mm) barb fittings are used in the installation of any brand name drip line or drip tubing. To connect the 1/2" (17 mm) drip tubing or drip line, use a hand pruner to cut the drip tubing or drip line, being careful to keep dirt from entering the drip tubing. Insert the barb side of the fitting into the end of the 1/2" drip tubing or drip line by forcing the drip tubing over the barb side.