Free shipping on orders $149 up. exclusions apply

180° Deflector for MS006 & MSA006, Color Orange

180° Deflector for MS006 & MSA006, Color Orange
In Stock

The 180-degree orange deflector can be snapped on top of the 360-degree 12-jet sprayer for pattern change. The spray assembly has a flow rate of 10 GPH @ 30 PSI with spray pattern of up to 6’ diameter.

Part #: DF180
$0.15 ea.

The Drip Store has a wide range of micro sprayers and jets to meet all of today‘s requirements for micro irrigation needs. The no moving parts 12-jet sprayers can be used for a wide range of applications and are available with 360° degree pattern and inserts for 90 and 180 degrees with a small diameter and for watering that requires small droplet size with low precipitation rates. When low volume overhead irrigation is desired for an area where drip emitters are not practical and micro sprinkler diameters and moving parts are not required nor preferred, the micro sprayers or jets may be what are needed. Like micro sprinklers, micro sprayers and jets are available in a wide variety of styles, flow rates, diameters, and configurations. Like micro sprinklers, they operate at low pressure and require a filter to protect the small orifice of the sprayer from clogging. The main advantage of micro sprayers to some users and growers could be the lack of moving parts and the small to medium sized droplets and coverage.

  • Assembly : 10/32 thread or fully assembled with spike, micro tubing and barb
  • Droplet Size: Small
  • Flow rate: 10 GPH @ 30 PSI with coverage of 3’ to 10' diameter.
  • Recommended filtration: 120 mesh
  • Recommended pressure: 15 to 30 PSI
  • Available on 10/32 thread and completely assembled on 13" spike with 24” (.160 ID x .270 OD) micro tubing and 1/4" barb
  • Can be attached into the end of 1/4" micro tubing or into the 1/2" drip tubing.
  • Can be replaced with one of two available deflectors
  • Color coded deflectors for easy identification
  • Trouble free operation with no moving parts

Installing 12 Jet Micro Sprayers

To install the 12-jet micro sprayer, use the complete assembly with spike, micro tubing and barb. You can use this sprayer with one of our poly riser assemblies available in our accessories section. To change the 360 degrees to 90 or 180 degrees snap one of the deflectors on top of the 360-degree pattern 12-jet sprayer.

To install the 12-jet micro sprayer, first select the flow rate if available, then the pattern. If using the complete assembly micro sprayerwith the spike and the micro tubing, first insert the spike into the ground about 2-4”, then punch a hole into the side of the drip tubing using a punch, and then insert the barb on the micro tubing into the drip tubing.