The Drip Store carries in stock a wide range of drip line or dripper line, with 6” to 24” emitter spacing, in 100', 250’ 500' and 1000' lengths Our drip line has flow rates of .5, .9 or 1 GPH. Our inline pressure compensating drip emitters are fully self-contained units welded into the interior wall of the drip tubing at a preset spacing. Both the tubing and drip emitters are manufactured using Dow FINGERPRINT™ DFDA-7510 NT linear low-density polyethylene resin with up to 5% Carbon black for extra resistance to the damaging effects of ultraviolet rays. This high quality material can withstand chemicals and fertilizers and offers year after year of operation. The inline PC drip emitters contain a diaphragm that continuously adjusts to varying water pressure to ensure a constant flow rate. The diaphragm inside the inline drip emitters allows particles to pass through the drip emitters without harming them, providing reliable performance and a longer life. The drip emitter’s wide flow path and the method of continuous flushing allow the drip emitters to operate at optimal flow rates under extreme conditions. The PC inline drip emitter discharges the same amount of water under a wide pressure range, providing high uniformity and longer run on any topography. Our non-PC drip line is available in 1/4" using our 1/4" barbed fittings. Our PC dripline in 16 or 17 mm is used with our 16 or 17 mm barbed fittings or the corresponding compression fittings (16mm uses green compression rings, 17 mm uses black color compression rings).
If you are shopping for drip irrigation system that required some type of drip line or drip tape, 1/4” drip line in 100’, 500’ or 1000’ with spacing of 6”, 9” or 12”, 1/2” (16 mm) drip line with drip spacing of 12”, 18” or 24”, 1/2” (17 mm) PC drip line with drip spacing of 12”, 18” or 24” and drip tape in 100', 500' and larger coils. The Drip Store have it all, welcome to The Drip Store, the largest supplier of drip irrigation components
Special Order quotes: The Drip Store can provides quotes on 1/2" pressure compensating drip line with a minimum order of 10,000'. The .5 and 1 GPH PC drip line are available at spacing of 12" 18", 24", 30", 36", and 48".
The Drip Store also has brand name drip tape in 100’, 250’, 500', and other longer lengths. The drip tape we have has pre-inserted drip emitters in preset spacing or labyrinth flow when the water path is along the drip tape. Drip tape can be installed above or below the ground with emitters facing up. Drip tape fittings are different in design from those used with 1/2" drip tubing, in that they work with a twisting lock device rather than with compression.
In our line we have a 1/4" laser drilled soaker hose that has a laser drilled hole every 6" or 12" for saturation coverage of the desired area, designed for short runs up to a maximum of 30 feet with a flow rate of .5 GPH per foot. Use it in containers, or for small, narrow watering areas. An arrow printed on the soaker hose shows the direction of the water. It may be extended from 1/2" drip tubing or 1/4" distribution tubing.