Free shipping on orders $149 up. exclusions apply

Palm Hole Punch

Palm Hole Punch

The palm hole-punch from DIG can be used to punch holes on any size drip tubing for the insertion of drip emitters, micro sprinklers, 1/4" barbs and 10/32 threaded barbs. The handle is made of UV-resistant, high impact plastic. The punch creates just the right sized hole in the drip tubing. This punch removes the residual debris formed as it punches a hole in the drip tubing. We recommend cleaning the punch every few holes to make sure that the material does not accumulate inside the metal pin. The main advantage of removing the waste material as you punch is to protect the drip emitters from plastic debris that can, over time, plug the drip emitters. Use a paper clip to remove the debris. This tools is not recommended to use with large amount of drip emitters.

Category: Punches & Tools

Available ModelsPartPrice
A019 : Palm Hole Punch Palm Hole PunchA019$1.74 ea.

Punches and drip tubing cutters are common tools used in the layout and installation of a micro irrigation system. The punches come in various sizes and are used to punch holes in the drip tubing for the insertion of drip emitters or 1/4" barbed fittings. The drip tubing cutters are used to cut the drip tubing where needed. Together, the punches and cutters provide the installer with the main tools needed for the installation of a drip irrigation system.

  • UV resistant, high impact plastic
  • Used to punch holes into the drip tubing or to cut the drip or micro tubing