Free shipping on orders $149 $99 & up. exclusions apply

Waterproof Splice Connectors


Waterproof Splice Connectors

Use the waterproof connectors to protect the controller and solenoid wires from moisture damage that can cause a short circuit.

Category: AC Controllers

Available ModelsPartPrice
SC010 : Waterproof Splice Connectors
Waterproof Splice ConnectorsSC010$0.65 ea.
SC010-10 : Waterproof Splice Connectors, Pack of 10
Waterproof Splice Connectors, Pack of 10SC010-10$6.30 ea.
SC010-25 : Waterproof Splice Connectors, Pack of 25
Waterproof Splice Connectors, Pack of 25SC010-25$15.00 ea.
SC020 : Direct Bury Wire Splice Connector
Direct Bury Wire Splice ConnectorSC020$0.96 ea.

  • Installation for Waterproof Splice Connectors

    AC solenoid: Cut the multi strand irrigation controller wire and and strip back 3/4" of the insulation from each colored wire used, including the common (white) wire, to expose the multi-strand copper conductor. Join one of the colored wires to each wire of the solenoid valve.  Since there is no polarity in low voltage it doesn't matter which side is which when joining the wires together. Then connect the other wire (common) from each solenoid to the exposed white (common) wire. Install a wire nut on each side and insert into the waterproof connector, and snap the connector together.

    If you have a problem with power to any of the valves installed, first visually inspect the waterproof connectors near the valve.  Then inspect the controller wires to insure there are no obvious loose or damaged leads.