Free shipping on orders $149 & up. exclusions apply

6-Outlet Drip Manifold with 1/2" FNPT


6-Outlet Drip Manifold with 1/2" FNPT

The 6-outlet drip manifolds from DIG Corporation are high flow emission devices with six swivels side outlets. By converting your sprinkler system to a drip irrigation system you can reduce evaporation, pest problems and weed growth, eliminate runoff, and have healthier plants.

Category: Retrofit 6-Outlets

Available ModelsPartPrice
D160 : 1/2 in.  FNPT 6.5 GPH per Outlet, 6-Outlet Drip Manifold with Swivel Side Outlet, Color Brown
1/2" FNPT 6.5 GPH per Outlet, 6-Outlet Drip Manifold with Swivel Side Outlet, Color BrownD160$3.30 ea.

  • Filter requirement
    • D160 : 80 Mesh
  • Flow rate and Color code:
    • D160 : 6.5 GPH per outlet: Brown
  • Inlet and outlet
    • D160 : Inlet size 1/2" FNPT; Outlet size 1/4" barb or barb elbow
  • Materials
    • D160 : Body and cover: high impact plastic
    • D160 : Diaphragm : Silicon
  • Operating pressure
    • D160 : up to 50 PSI
  • Use with
    • D160 : 1/4" (.150 -.160 ID) distribution tubing
  • Install above grade or place below grade in a 6" emitter box
  • Rugged materials to withstand the most adverse conditions
  • Six pressure compensating, self flushing outlets allow easy passage of water and minimize clogging
  • Swivel barb outlets allow installation flexibility and protection of the flow control
    • Installation for Retrofitting 4 & 6 Outlet

      Retrofitting a conventional sprinkler system to a low flow, water saving drip irrigation system requires a few simple steps:

      Step 1: Evaluate the areas to be watered. While large areas such as lawns are best watered by sprinklers, other areas, such as shrubs, trees, roses, or individual plants, can be irrigated more efficiently by using the retrofit drip heads.

      Step 2: Remove the sprinkler head from the riser.

      Step 3: Turn the water on and flush the line.

      Step 4: Screw the 4-outlet drip head onto the riser.

      Step 5: extend a 1/4” micro-tubing from the drip head to the plants or combine the micro tubing with 1/4" drip line

      Step 6: Secure the 1/4"" micro-tubing with a 1/4" stake and insert the stake to ground near the plant area