Free shipping on orders $149 up. exclusions apply

Large "O" Ring for Bayonet Assembly

Large  in. O in.  Ring for Bayonet  Assembly
In Stock

The bayonet assembly is part of the solenoid assembly for the 510 battery operated controller and the 337 valves. The bayonet assembly is attached below the solenoid and has a 3/4" 20 thread.

Part #: C103
$0.33 ea.

The bayonet assembly includes the bayonet housing, yellow puppet or magnet, large O-ring and small O-ring. The bayonet assembly holds the solenoid on our C017-C029, 3/4” through 2” (DIG 510-075 to 510-200) battery operated controllers and model C026 - C028 solenoids with inline valve (DIG model Inside the bayonet assembly the puppet can be found supported by a large O-ring and on the bottom of the bayonet assembly the small O-ring can be found, supporting the solenoid opening and closing. If any of the bayonet assembly parts are missing, the valve will stay open.

Installation for Bayonet Assembly

Steps to replace a bayonet assembly or any part of the bayonet assembly on a 3/4", 1”, 1-1/2” or 2” inline valve of the battery operated controller (DIG 510 series):

1.       Shut off the water supply to the valve.

2.       Turn on the valve via the manual lever or via the solenoid - first make sure that the valve is not under pressure and then drain the valve.

3.       Remove the controller from the solenoid and then turn the solenoid counter-clockwise to remove.

a.       If a new bayonet assembly is needed, remove the old bayonet by turning it counter clockwise (bayonet will "rub" slightly on the flow control base upon removal/installation). After removing it make sure that the small O-ring model C102 located between the bayonet assembly and the valve solenoid thread is on the bottom of the bayonet assembly; if not, see if it is on the valve solenoid thread bottom. If the 0-ring is missing add a new small O-ring, otherwise the valve will never close.

b.      Inside the bayonet assembly you will see the puppet model C104. If the bayonet assembly is empty, then you need to have a new puppet. The puppet assures that the valve will open and close; if it is missing the valve will stay open. Check the puppet and make sure that the puppet is moving up and down freely and that the yellow plastic housing is on the top.  (If yellow plastic housing is upside down and you can see the puppet spring, then the valve will remain open.) Change the position of the puppet if needed.

c.       If the solenoid is leaking then the large 0-ring model C103 is missing or damaged. Remove the solenoid by turning it clockwise, and check the O-ring. The O-ring may be inside the bayonet housing or on the outlet side of the solenoid. If needed, replace using the new O-ring model C103.

4.       After completing the repair or replacement, turn the water on again and test the valve under pressure to make sure no leak occurs, using the manual leaver.