The model D170 drip irrigation retrofit kit includes 12-outlet manifold with 1 GPH per outlet and 100' 1/8" vinyl micro tubing made by DIG Corporation. This kit is used to convert a 1/2" sprinkler riser into a 12-outlet, low flow, water efficient drip irrigation system.
See Added Parts to expand your system by purchasing additional pieces separately.
The TOP irrigation retrofit has twelve pressure-compensating replaceable nozzles for watering up to twelve individual plants, a small group of plants, areas with difficult terrain, windy areas or oddly shaped areas that a sprinkler head cannot reach. Retrofitting some of the sprinkler risers into a drip system will not have any effect on the sprinkler system’s total flow rate. The Drip Irrigation Retrofit Kit includes a 1/2" FNPT 12-outlet pressure-compensating manifold head with a flow rate of 1 GPH (gallon per hour) per outlet. The D170 Drip Irrigation Retrofit Kit also includes 100’ of high quality 1/8” micro tubing and all the components needed to install the kit.
Drip irrigation is the slow application of water directly to the plants' root zone in a predetermined pattern. Maintaining an optimum moisture level in the soil at all times results in less water lost to the sun and the wind. No water is wasted on non-growth areas, and the root zone is maintained at its ideal moisture level, combining the proper balance of water and air for a very efficient irrigation system.
One of the most important features of a drip irrigation system is the creation of a totally new and more favorable root zone environment within the planting. Drip irrigation sustains this environment by using low flow rates to maintain constant soil moisture levels. This encourages better growth and disease resistance by reducing plant stress
Note: The micro tubing can be buried or covered with mulch, but the end should be left above ground.
See installation instructions inside for details.
How much time to water:
For using the drip irrigation retrofit head only: If the system is comprised of only drip irrigation retrofit manifolds, then turn the water onfor 20 to 45 minutes every two to three days, depending on your location and the soil type. After a week or two check the soil and the health of the plants, and adjust the irrigation time as needed. If you have an irrigation controller and you need to add more time, adjust the time on the irrigation controller or program the controller with additional start times.
For a mix of sprinklers and drip irrigation system:If the irrigation system is comprised of pop up sprinklers and one or more drip irrigation heads then turn the water onfor the same time that the sprinkler system was running. After a week or two check the soil and the health of the plants, and adjust the location of the drip outlets. If more water is needed, add additional drip irrigation outlets 6 to 10” from the plant.
|Kit Qty||Part #||Image||Description|
|12||A127||5” Flow Stabilizer Stake with Barb for 1/8” Micro Tubing|
|12||D064||Purple Barb Converter|
|1||D071||12-Outlet PC Drip Manifold on 1/2" FNPT with 1 GPH per Outlet|
|1||D074||TOP Bug Plugs|
|1||D075||TOP Rubber Caps|
|1||T019||100’, 1/8" (.118 ID x .187 OD) Vinyl Black Micro Tubing|
|KIT D170 contains a total of 28 pcs. for $12.98|