Free shipping on orders $149 & up. exclusions apply

1" Swivel Tee (1" Spin-loc x 3/4” FHT x 1" Spin-Loc)


1 in.  Swivel Tee (1 in.  Spin-loc x  3/4” FHT  x 1 in.   Spin-Loc)
In Stock

The commercial grade ¾” FHT swivel tee x 1" Spin-Loc is used to connect two ends of 1” drip tubing with 1.060 ID x 1.200 OD to a 3/4" male hose thread connection, faucet, or pressure regulator to layout a drip system in two directions. To use this Spin-Loc fitting, push the drip tubing over the barb with the "O" ring and thread the sleeve over the drip tubing to secure. The tight seal for the Spin-Loc fittings is ensured by the rubber "O" ring on the barb, which provides quality water-tight connection.

Part #: LF108
$5.09 ea.

The Drip Store’s commercial grade Spin-Loc fittings are available in many configurations to meet the demands of all types off drip irrigation applications. Use the 1" Spin-Loc fittings in the layout and installation of 1” drip tubing.

The Spin-Loc fittings use a sleeve assembly over a body with a barb might be needed throughout the installation of the drip tubing. The sleeve makes the Spin-Loc fittings easier to install and tighten. An advanced sealing interface with a long barb provides guides for the Spin-Loc to slide over the barb for a secure seal. Our Spin-Loc fittings are made of high impact UV resistant plastic and can last for many years.

  • Flush Valve Closing Pressure: 7 PSI
  • Flush Valve Opening Pressure: 7 PSI
  • Maximum pressure: 60 PSI
  • Recommended pressure: Up to 30 PSI
  • Available to fit 1/2", 3/4" and 1” drip tubing or drip line
  • Made with high impact UV resistant plastic
  • No glue or tools are required
  • Secure and easy installation without glues or clamps
  • Tight seal, ensured by the rubber "O" ring on the barb ( 3/4" & 1" do not use an "O" ring)

Installation for Spin-Loc Fittings

The ½”, ¾” and1” Spin-Loc fittings uses a sleeve assembly over a body with a barb insert, allowing the user to easily install the many fittings configurations that night be needed throughout the installation of the drip tubing. The sleeve makes the Spin-Loc fittings easier to install and tighten. An advanced sealing interface with a long barb provides guides for the Spin-Loc to slide over the barb for a secure seal. Our Spin-Loc fittings are made of high impact UV resistant plastic and can last for many years.
 
To connect the spin-lock fitting to the drip tubing or drip line we provides a number of steps
Step 1: First, turn the sleeve of the fitting counter-clockwise
Step 2: Push the drip tubing or drip line over the barb all the way in or as much as you can
Step 3: Threaded the sleeve over the drip tubing or drip line to secure.
 
Using the Spin-Loc fittings, drip tubing can be installed easily either above or below the ground. Use the Spin-Loc fittings to connect the drip tubing with other sections of drip tubing or PVC pipe.