Free shipping on orders $149 up. exclusions apply

1/2" (16mm) .520 to .540 ID Barbed Elbow

1/2 in.   (16mm) .520 to .540 ID Barbed Elbow
In Stock

The 1/2" (16 mm) barb elbow is used to connect two ends or to make a 90 degree turn in drip tubing or drip line with .520 OD to .540 ID (16 mm). By using a double barb, the tubing is pushed over the barb for a very tight fit. Use for continuing lengths of drip tubing or drip line and for drip tubing repair.

Part #: LF302
$0.41 ea.

The Drip Store's black color 1/2" (16 mm) barbed drip fittings are available in a variety of configurations for 1/2" drip line or drip tubing with .520 to .540 (16mm) ID, providing a low cost and simple method for drip line and drip tubing installation.

  • Color: Black
  • Materials: Barb: Acetal
  • Operating pressure: up to 30 PSI
  • Use with: 1/2" drip tubing or drip line with .520 ID to .540 ID
  • Fits all brands of 1/2" (16 mm) polyethylene tubing or drip line with .520 ID to .540 ID
  • Made with high impact UV resistant plastic
  • Secure and easy installation without glues or clamps

1/2" Barb Fitting suggested installation steps


The 1/2" (16mm) barb fittings are used in the installation of any brand name drip line or drip tubing. To connect the 1/2” (16 mm) drip tubing or drip line, use a hand pruner to cut the drip tubing or drip line, being careful to keep dirt from entering the drip tubing. Insert the barb side of the fitting into the end of the 1/2” drip tubing or drip line by forcing the drip tubing over the barb side.