3/4" Compression Elbow (.940 OD)

3/4" drip tubing can be a little difficult to work with, especially when it comes to tight angles. Too tight an angle will kink the tubing and prevent water from flowing, but nice clean turns look so good! Luckily, the LF331 3/4" compression elbow fixes exactly that problem. This item will let you make a clean, sharp right angle with your 3/4" mainline tubing without risking a kink or needing to use a bunch of stakes to hold it in place.

This fitting (and all the other products on our 3/4" fittings page) works with .820 ID x .940 OD poly drip tubing. Push the tubing into the end of the fitting firmly and at an angle, then walk it up and down while pushing in until the tubing is inside the fitting by at least half an inch. Be aware that once you've gotten the tubing into the fitting it's very difficult to remove it!