.940 x .700 x .940 Reducer Tee w/ Ball Valve

The more water that needs to run through a pipe, the larger that pipe needs to be. This is why you often see larger pipes as the main supply lines of a system, with smaller pipes coming off of them. This custom-assembled tee is perfect for branching a 1/2" poly sub-line off a 3/4" poly mainline. It is compatible with both 3/4" .940 OD and 1/2" .700 OD poly drip tubing. As an added plus, this assembly includes a ball valve, giving you manual control over the sub-line you're installing.

To use this fitting, push the tubing into the end of the fitting firmly and at an angle, then walk it up and down while pushing in until the tubing is inside the fitting by at least half an inch. Be aware that once you've gotten the tubing into the fitting it's very difficult to remove it!