3/4" x 1/2" x 3/4" Spin-Loc Reducer Tee

The 1/2" spin-loc fittings that we sell are more expensive than comparable compression or barbed fittings, but they make up for it by being easier to work with than compression fittings and much more secure than barbed fittings without the need for an additional ratchet clamp to hold them in place. They will work with any 1/2" .600 ID x .700 OD poly drip tubing no matter where you purchased it. Constructed of UV-resistant high-impact plastic, these fittings are as durable as the tubing they are designed to work with. The 1/2" elbow will allow you to make tighter turns with 1/2" tubing than would otherwise be possible. Too tight a turn will cause the tubing to kink, cutting off water flow. Using this item will prevent that.