The spot-spitter spray stick controls water flow at the emitter stick, where it matters most. Other mini-sprayer sticks may require tedious, labor-intensive modifications of tubing and lengths to develop the flow characteristics desired. You can install the spot-spitter in seconds, selecting the proper flow rate and pattern and using the correct 1/8” micro tubing with the specified ID. Unlike other mini-sprayer sticks which tend to deform or break at the spray tip, the spot-spitter is made from premium UV-resistant resins, which resist tip damage and provide years of trouble-free operation in both indoor and outdoor applications.
Note: the flow rate is achieved at a pressure rating of 15 to 25 PSI and using the 1/8” micro tubing with 0.125 ID x .0.187 OD.
To install the Spot-Spitter, use the suggested micro tubing with the correct ID and OD.
To replace the spray stick, just pull it out of the micro tubing, and replace with a new head of the same color.
Make sure to flush the line before inserting the new spray stick. No tool or glue is required.
Select the flow rate and the spray stick degree of coverage, then insert the spray stick into the 1/8” micro tubing.
Cut the end of the 1/8" tubing to be inserted in the main line at a 45 deg angle
Punch a hole into the side of the drip tubing using a Spot-Spitter 4 mm punch, and then insert the 45 deg cut end of the micro tubing into the main line
No barb connector or other parts are needed.