Spot-Spitter Spray Stick, 90 Deg.\ Gray \ Mini Flow 2.4-3.6 GPH

The spot-spitter spray stick controls water flow at the emitter stick, where it matters most. Other mini-sprayer sticks may require tedious, labor-intensive modifications of tubing and lengths to develop the flow characteristics desired. You can install the spot-spitter in seconds, selecting the proper flow rate and pattern and using the correct 1/8” micro tubing with the specified ID. Unlike other mini-sprayer sticks which tend to deform or break at the spray tip, the spot-spitter is made from premium UV-resistant resins, which resist tip damage and provide years of trouble-free operation in both indoor and outdoor applications.

Note: the flow rate is achieved at a pressure rating of 15 to 25 PSI and using the 1/8” micro tubing with 0.125 ID x .0.187 OD.

Installation for Spot Spitters:

To install the Spot-Spitter, use the suggested micro tubing with the correct ID and OD.

To replace the spray stick, just pull it out of the micro tubing, and replace with a new head of the same color.

Make sure to flush the line before inserting the new spray stick. No tool or glue is required.

To install the Spot-Spitter into the drip tubing lateral:

Select the flow rate and the spray stick degree of coverage, then insert the spray stick into the 1/8” micro tubing.

Cut the end of the 1/8" tubing to be inserted in the main line at a 45 deg angle

Punch a hole into the side of the drip tubing using a Spot-Spitter 4 mm punch, and then insert the 45 deg cut end of the micro tubing into the main line

No barb connector or other parts are needed.